Reassign the wireless propaq cs to a new patient – Welch Allyn 246 Propaq CS Vital Signs Monitor v.3.7X - User Manual User Manual
Page 84
80
Acuity
Welch Allyn Propaq CS Vital Signs Monitor
Reassign the Wireless Propaq CS to a new patient
If you want to discontinue monitoring a patient and connect the Wireless Propaq CS to a
new patient, follow these steps.
1.
From the Main Menu, press SETUP, ACUITY, END TELE.
2.
Turn off the monitor power, then turn it on again after a few seconds.
As an alternative to Steps 1 and 2, from the Main Menu you can press SETUP,
ACUITY, PATIENT, NEW PAT for the same result.
The monitor then presents a series of menus and messages requesting you to
provide information about the connection and patient. The actual screens presented
depend on how the Acuity System is configured.
Provide the information as requested. This may include:
•
Select an Acuity unit.
•
Select a patient from the patient list. (After you select a new patient, all monitor
operating settings are reset to the Acuity System default powerup settings.)
•
Select a patient room from the room list.
If you do not select the patient name or room while connecting the patient, you will
need to do that later at the Acuity Central Station. See Acuity Directions For Use for
more information.