Acronis Access - Installation Guide - Manual (Page 77)

77 Copyright © Acronis International GmbH, 2002-2014
7 Quick Start: Sync & Share
This guide provides the essential steps for setting up Sync & Share, using the web interface to access
files and using the Acronis Access desktop client. For more detailed instructions on configuring these
components, see the Sync & Share and Desktop Client sections.
In this section
First Run ................................................................................................... 77
Web Client ................................................................................................ 82
Using the desktop client .......................................................................... 89
7.1 First Run
If you haven't done so already, install and configure Acronis Access. For more information on doing
so, check the Installing (p. 5) and Configuration Utility sections.
When you first open the web interface, you will have to set a password for the default administrator
account and after you log in, you will be greeted by the Setup Wizard.
Warning! Please do not forget your administrator password as the support department cannot recover this
password for you
Note: It may take 30-45 seconds until the application becomes available after starting it from the Configuration
Utility.
Once you have completed the above, you are ready to go through the Initial Configuration described
below.
General Settings
1. Enter a Server Name.