Acronis Access - Installation Guide - Manual (Page 67)

67 Copyright © Acronis International GmbH, 2002-2014
5 Quick Start: Mobile Access
This guide provides the essential steps for configuring your Group Policy, adding a Data Source and
installing the Access Mobile Client app. For more detailed instructions on configuring the Acronis
Access Gateway Server and the management components, see the Mobile Access (p. 31) section.
In this section
First Run ................................................................................................... 67
Configuring your Group Policy ................................................................. 72
Installing the Access Mobile Client application ....................................... 72
Enrolling in client management ............................................................... 72
5.1 First Run
If you haven't done so already, install and configure Acronis Access. For more information on doing
so, check the Installing (p. 5) and Configuration Utility sections.
When you first open the web interface, you will have to set a password for the default administrator
account and after you log in, you will be greeted by the Setup Wizard.
Warning! Please do not forget your administrator password as the support department cannot recover this
password for you
Note: It may take 30-45 seconds until the application becomes available after starting it from the Configuration
Utility.
Once you have completed the above, you are ready to go through the Initial Configuration described
below.
General Settings
1. Enter a Server Name.