Rockwell Automation Flex/WebPak 3000 DC Drive ControlNet, Network Communication Board, 915FK2101 - Manual (Page 59)

Register Map for FlexPak 3000 Drives 7-7
N10:166 ANLG TACH VOLTS /1000 P.203 Config 1 = 0.1 volts/1000 RPM
N10:167 PULSE TACH PPR P.207 Config 1 = 1 PPR
N10:168 PULSE TACH QUADRATURE P.208 Config 0 = OFF , 1 = ON
N10:169 OCL PROP TRIM SELECT P.813 Config 0 = DISABLED , 1 = ENABLED
N10:170 OCL FEEDBACK SELECT P.804 Config 0 = NONE
1 = CML FEEDBACK
2 = ANALOG IN 1
3 = ANALOG IN 2
4 = SPEED LOOP OUTPUT
5 = ANALOG AUTO REFERENCE
6 = NETW IN REG 1
7 = NETW IN REG 2
8 = NETW IN REG 3
N10:171 OCL TYP 3 POSN REG P.814 Config 0 = DISABLED , 1 = ENABLED
N10:172 MOTOR HOT FLD AMPS P.510 Config 1 = 0.01 amp
N10:173 FIELD REF SELECT P.521 Config 0 = REGISTER
1 = ANALOG MAN TRIM REF
2 = ANALOG IN 1
3 = ANALOG IN 2
N10:174 FIELD DELTA HIGH LIM P.587 Config 1 = 1 deg
N10:175 FIELD LOSS THRESHOLD P.512 Config 1 = 1% of MOTOR HOT FLD AMPS (P.510)
N10:176 FIELD AUTO WEAKEN P.517 Config 0 = DISABLE , 1 = ENABLE
N10:177 CT TURNS RATIO P.010 Config
N10:178 MOP RESET ENABLE P.116 Config 0 = OFF , 1 = ON
N10:179 JOG OFF DELAY TIME P.121 Config 1 = 0.1 s
N10:180 STOP DECEL SELECT P.122 Config 0 = DECELERATION TIME
1 = RAMP STOP DECEL TIME
N10:181 NOMINAL AC LINE FREQ P.306 Config 1 = 1 Hz
N10:182 NOMINAL AC LINE VOLTS P.307 Config 1 = 1 VAC
N10:183 PHASE LOSS DETECT EN P.609 Config 0 = DISABLE , 1 = ENABLE
N10:184 DIG OUT 1 SELECT P.409 Config 0 = LEVEL DETECT 1 OUTPUT
1 = LEVEL DETECT 2 OUTPUT
2 = IN CURRENT LIMIT
3 = DRIVE READY
4 = NETW COMM STATUS
5 = NETW IN REG 1 ( BIT 0)
6 = NETW IN REG 2 ( BIT 0)
7 = NETW IN REG 3 ( BIT 0)
N10:185 DIG OUT 1 CONTACT TYP P.410 Config 0 = NORMAL OPEN
1 = NORMAL CLOSED
Table 7.1 – File N10:x (Drive Read/Write Parameters) for FlexPak 3000 Drives (Continued)
File
Address Parameter Name
Parameter
Number Type Scale