Rockwell Automation Flex/WebPak 3000 DC Drive ControlNet, Network Communication Board, 915FK2101 - Manual (Page 37)

Configuring ControlLogix Applications 5-3
Step 3. Enter a Name, Slot number, and Revision number (figure 5.4). Click Next>.
Step 4. This step is used to define controller-to-module behavior (figure 5.5). Inhibit Module
inhibits/un-inhibits the connection to the module. The Major Fault check-box selects
if a failure on the connection of this module causes a major fault on the controller if
the connection for the module fails. Click Next>.
Figure 5.4 – Module Properties: Name Selection
Figure 5.5 – Module Properties: Controller-to-Module Behavior Screen