Rockwell Automation Flex/WebPak 3000 DC Drive ControlNet, Network Communication Board, 915FK2101 User Manual

Page 14

2-2

ControlNet Network Communication Option Board For Use With FlexPak 3000 and WebPak 3000 DC Drives

Step 4. Remove the screws that attach the carrier shield to the carrier. See

figure 2.2.

Step 5. Remove the connector that attaches the shield ground wire to the drive

power supply. Set the shield aside. See figure 2.3.

Step 6. Position the network option board over the standoffs. Refer to figure 2.4.

Step 7. Secure the network option board using three captive screws on the board.

Step 8. Plug the network option board ribbon cable into the network option board.

Figure 2.2 – Removing the Carrier Shield

Figure 2.3 – Removing the Shield Ground Wire

Carrier Shield

Ground Wire

Power Supply