Configure device accessories – Rockwell Automation 284D On-Machine ArmorStart Accelerator Toolkit User Manual
Page 22

22
Publication IASIMP-QS015C-EN-P - August 2011
Chapter 1
Hardware Selection
Configure Device Accessories
Follow these steps to configure the device accessories.
You will need to add one input and two output cables for the photoelectric sensor and stack lights
respectively that will be added later to the BOM in ProposalWorks.
1. Click Output Cable Port #1.
2. Make the following selections.
a. Select Cable Type under the
First Cable Type Selection
b. Under Cable Type, choose
‘Cordset-Male’.
3. Configure the ‘Cordset-Male’ as
shown by clicking the ‘?’ next to
‘Cable Configuration Port 1’.
This manual is related to the following products: