Rockwell Automation 2727-T7P30D1F MobileView Tablet T750 User Manual - Manual (Page 76)

Publication 2727-UM001D-EN-P - March 2004
5-22 Communications Configuration
4. Click OK to enable LEAP and exit the utility. When LEAP is
enabled, the following parameters in the ACU screen are
changed automatically:
•
WEP is set to Enabled.
•
Authentication Type is set to Open.
Entering the LEAP Username and Password
Follow the steps below to enter the LEAP username and password.
1. WLM starts automatically whenever you start ACU with a client
adapter inserted, change the LEAP parameter from Disabled to
Enabled, and click OK. If LEAP is already enabled, WLM starts
automatically whenever you insert the client adapter, reboot or
reset the Windows CE device, or load new firmware.
When WLM starts, the Wireless Login Module screen appears.
2. Obtain the username and password for your RADIUS server
account from your system administrator.
3. Enter the username in the User Name field.
TIP
You can also start WLM by selecting
Start/Programs/Cisco/Wireless Login Module.
You may want to do this if you inadvertently
exited WLM after it started or if you roam to a
different part of the network where a different
login is required.
TIP
The password is optional because not all host
accounts on the RADIUS server are set up with
a password.