Rockwell Automation 2727-T7P30D1F MobileView Tablet T750 User Manual - Manual (Page 42)

Publication 2727-UM001D-EN-P - March 2004
3-18 General Tablet Operation and Configuration
3. To adjust the double-tap sensitivity, tap the Double-Tap tab and
follow the instructions there.
4. To calibrate the screen, tap the Calibration tab, then tap the
Recalibrate button.
5. Press and briefly hold the stylus on the center of the target.
Repeat as the target moves around the screen.
6. Press the Enter button to accept the new settings.
7. Tap OK to close the window.
Setting the Date and Time Follow these steps to check and set the date and time properties:
1. Tap on the Start button and select Settings, Control Panel from
the menu.
2. Double-tap on the Date/Time icon to open the Date/Time
Properties dialog box.
Tabs
Recalibrate
button
TIP
While calibrating, be careful not to lean your
hand on the screen or touch the screen, except
with the stylus. If you miss the center of a target
with the stylus, keep the stylus on the screen and
slide it to the target’s center, then lift the stylus.
TIP
To quit calibration without saving the changes,
simultaneously press the left and right arrow
buttons to Escape.