Rockwell Automation 2727-T7P30D1F MobileView Tablet T750 User Manual - Manual (Page 55)

1 Publication 2727-UM001D-EN-P - March 2004
Chapter
5
Communications Configuration
RF Network
Communications IP Address Configuration
The internal Cisco wireless LAN adapter is preconfigured to obtain an
IP address via DHCP. If a specified IP address is desired, perform the
following steps.
Remote Communication
Your network configuration affects how you remotely communicate
with an internet, intranet, or between two or more MobileView
Tablets. Since there are a variety of possible network configurations,
we recommend you contact your network administrator or internet
service provider (ISP) to help set up remote communications. The
network administrator or ISP should be able to provide the necessary
configuration information, such as the network configuration settings,
the network architecture, and an IP address for the Tablet (if needed
with your installation).
The following is an example of a remote communication setup, using
a radio frequency (RF) network interface card, installed inside the
MobileView Tablet. This installation also requires a properly
configured access point for the RF signal.
Example of an RF Network Configuration
1. Tap on the Start button and select Settings, Control Panel from
the menu.
2. Double-tap on the Network icon.
3. Tap the Adapters tab in the Network Configuration dialog box.
4. Select Cisco Wireless LAN Adapter from the list of drivers, then
tap the Properties button.