Rockwell Automation 2727-T7P30D1F MobileView Tablet T750 User Manual - Manual (Page 61)

Publication 2727-UM001D-EN-P - March 2004
Communications Configuration 5-7
World Mode Enables the client adapter to adopt the maximum transmit
power level and the frequency range of the access point to
which it is associated, provided the access point is also
configured for world mode. This parameter is available only in
infrastructure mode and is designed for users who travel
between countries and want their client adapters to associate
to access points in different regulatory domains.
Options: Enabled or Disabled
Default: Disabled
Note: When World Mode is enabled, the client adapter is
limited to the maximum transmit power level allowed by the
country of operation’s regulatory agency.
Data Rates Specifies the rate at which your client adapter should transmit
or receive packets to or from access points (in infrastructure
mode) or other clients (in ad hoc mode).
Auto is recommended for infrastructure mode; setting a
specific data rate is recommended for ad hoc mode.
Options: Auto, 1 Mb Only, 2 Mb Only, 5.5 Mb Only, or 11 Mb
Only
Default: Auto
Auto: Uses the 11 Mbps data rate when possible but drops to
lower rates when necessary.
1 Mb Only: Offers the greatest range but the lowest
throughput.
2 Mb Only: Offers less range but greater throughput than the
1 Mbps Only option.
5.5 Mb Only: Offers less range but greater throughput than
the 2 Mbps Only option.
11 Mb Only: Offers the greatest throughput but the lowest
range.
Note: Your client adapter’s data rate must be set to Auto or
must match the data rate of the access point (in infrastructure
mode) or the other clients (in ad hoc mode) with which it is to
communicate. Otherwise, your client adapter may not be able
to associate to them.
Note: If ACU is running but a client adapter is not currently
inserted in the Windows CE device, the data rate options are
based on the last adapter that was running in the system.
Parameter Description