Rockwell Automation 2727-T7P30D1F MobileView Tablet T750 User Manual - Manual (Page 75)

Publication 2727-UM001D-EN-P - March 2004
Communications Configuration 5-21
Using LEAP This section provides instructions for enabling LEAP and entering the
LEAP username and password.
Enabling LEAP
Follow the steps below to enable LEAP for your client adapter.
1. Double-tap the Cisco ACU icon or select
Start/Programs/Cisco/Aironet Client Utility. The ACU screen
appears.
2. Select LEAP under Property.
3. Select Enabled in the Value box.
TIP
LEAP is supported only on client adapters that
support WEP and use firmware version 4.13 or
greater.
TIP
In order to use LEAP authentication, your client
adapter and access point firmware must have
matching 802.1X draft standards. That is, if the access
point uses draft 8 firmware (prior to 11.06) or has
draft 8 selected, the client adapter must use draft 8
firmware (prior to 4.25.x). Similarly, if the access
point uses draft 10 firmware (11.06 or later) and has
draft 10 selected, the client adapter must use draft 10
firmware (4.25.x or later).