Rockwell Automation 2727-T7P30D1F MobileView Tablet T750 User Manual - Manual (Page 19)

Publication 2727-UM001D-EN-P - March 2004
Quick Start 2-3
Power Save Reactivation
The MobileView Tablet 750 also includes a battery power saving
feature that suspends Tablet operations, including screen operations,
if Tablet is idle beyond suspend timer setting. The default setting is 5
minutes. To reactivate Tablet, press any of the program, navigational,
or start/enter buttons. If the AC Adapter/Charger is connected, tapping
the touch screen will also reactivate the Tablet.
RF Network Configuration IP Address Configuration
The internal Cisco wireless LAN adapter is preconfigured to obtain an
IP address via DHCP. If a specified IP address is desired, perform the
following steps.
Remote Communication
Your network configuration affects how you remotely communicate
with an internet, intranet, or between two or more MobileView
Tablets. Since there are a variety of possible network configurations,
we recommend you contact your network administrator or internet
service provider (ISP) to help set up remote communications. The
network administrator or ISP should be able to provide the necessary
configuration information, such as the network configuration settings,
the network architecture, and an IP address for the Tablet (if needed
with your installation).
The following is an example of a remote communication setup, using
a radio frequency (RF) network interface card, installed inside the
MobileView Tablet. This installation also requires a properly
configured access point for the RF signal.
Example of an RF Network Configuration
1. Tap on the Start button and select Settings, Control Panel from
the menu.
2. Double-tap on the Network icon.
3. Tap the Adapters tab in the Network Configuration dialog box.