Rockwell Automation 2727-T7P30D1F MobileView Tablet T750 User Manual - Manual (Page 58)

Publication 2727-UM001D-EN-P - March 2004
5-4 Communications Configuration
Parameter Description
SSID The service set identifier (SSID) identifies the specific wireless
network that you want to access.
Range: You can key in up to 32 characters (case sensitive)
Default: A blank field
Note: If you leave this parameter blank, your client adapter can
associate to any access point on the network that is configured
to allow broadcast SSIDs (see the AP Radio Hardware page in
the access point management system). If the access point with
which the client adapter is to communicate is not configured to
allow broadcast SSIDs, the value of this parameter must match
the SSID of the access point. Otherwise, the client adapter
cannot access the network.
Client Name A logical name for your Windows CE device. It allows an
administrator to determine which devices are connected to the
access point without having to memorize every MAC address.
This name is included in the access point’s list of connected
devices.
Range: You can key in up to 16 characters
Default: A blank field
Note: Each computer on the network should have a unique
client name.
Infrastructure Mode Specifies the type of network in which your client adapter is
installed.
Options: Yes or No
Default: Yes
Yes: Indicates that your wireless network is connected to a
wired Ethernet network through an access point.
No: Indicates that your wireless network consists of a few
wireless devices that are not connected to a wired Ethernet
Network through an access point (referred to as ad hoc mode).