Rockwell Automation 2727-T7P30D1F MobileView Tablet T750 User Manual - Manual (Page 70)

Publication 2727-UM001D-EN-P - March 2004
5-16 Communications Configuration
Viewing the Client Adapter’s Current Static WEP Key Settings
Follow the steps below to view the client adapter’s current static WEP
key settings.
1. If you entered the password correctly in the Enter Password
screen, the CEM screen appears.
A checkmark appears in the Already Set? box for all existing
static WEP keys.
2. Perform one of the following:
•
If no static WEP keys have been set, go to the “Entering a New
Static WEP Key and Enabling Static WEP” section on page 5-17
to set up one or more static WEP keys.
•
If you want to use an existing static WEP key, make sure the
Transmit Key button to the left of the key is selected and click
OK. This is the key that will be used to transmit packets. Then
open ACU and make sure WEP is enabled.
•
If you want to overwrite an existing static WEP key, go to the
“Overwriting an Existing Static WEP Key” section on page 5-18.
TIP
For security reasons, the codes for existing
static WEP keys do not appear on the screen.