Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) User Manual

Page 514

(HHP) User Manual

Index
MicroLogix

t 1000 with Hand-Held Programmer

I–10

using the MSG instruction, 15–12

application specific instructions

about, 13–1
bit shift instructions, overview, 13–2
Bit Shift Left (BSL), 13–3
Bit Shift Right (BSR), 13–4
in the paper drilling machine application

example, 13–20

Selectable Timed Interrupt (STI) function,

overview, 13–15

sequencer instructions, overview, 13–6

applying logic to your schematics, 6–11

basic instructions

about, 8–2
bit instructions, overview, 8–3
branch instructions, overview, 8–9
counter instructions, overview, 8–21
in the paper drilling machine application

example, 8–28

timer instructions, overview, 8–14

baud rate

changing, 19–6, 19–7
limitations for autoswitching, 3–13

bidirectional counter

operation, 14–9
overview, 14–5

bidirectional counter with quadrature encoder

operation, 14–13
overview, 14–5

bidirectional counter with reset and hold

operation, 14–9
overview, 14–5

bidirectional counter with reset and hold with

quadrature encoder

operation, 14–13
overview, 14–5

bit file (B), 6–4

bit instructions

And (AND), 8–3
And Block (ANB), 8–12
And Inverted (ANI), 8–4
Load (LD), 8–3
Load Inverted (LDI), 8–4
Load True (LDT), 8–6
Memory Pop (MPP), 8–10
Memory Push (MPS), 8–10
Memory Read (MRD), 8–10
One-Shot Rising (OSR), 8–7
Or (OR), 8–3

Or Block (ORB), 8–12
Or Inverted (ORI), 8–4
Or True (ORT), 8–6
Output (OUT), 8–8
overview, 8–3
Reset (RST), 8–8
Set (SET), 8–8

bit shift instructions, overview, 13–2

effects on index register S24, 13–3
entering parameters, 13–2
entering the instructions, 13–2

Bit Shift Left (BSL), 13–3

effects on index register, 13–3
entering parameters, 13–2
entering the instruction, 13–3
execution times, 13–3
function code, 13–3
instruction parameters, C–3
ladder representation, 13–3
operation, 13–4
valid file types, C–3

Bit Shift Right (BSR), 13–4

effects on index register, 13–3
entering parameters, 13–2
entering the instruction, 13–4
execution times, 13–4
function code, 13–5
instruction parameters, C–3
ladder representation, 13–4
operation, 13–5
valid addressing modes, C–3
valid file types, C–3

branch instructions, overview, 8–9

branching

input, 6–13
nested, 6–14
output, 6–13

BSL, Bit Shift Left, 13–3

BSR, Bit Shift Right, 13–4

cables

planning routes for DH-485 connections,

D–13

selection guide for the AIC+, 3–8
selection guide for the DeviceNet network,

3–14

Calculating the Software Calibration, F–2

calibrating an analog input channel, F–1

CE mark, 1–1