Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 17)

1 Chapter
1–1
Installing Your Controller
This chapter shows you how to install your MicroLogix 1000 Programmable
Controller. The only tools you require are a Flat head or Phillips head
screwdriver and drill. Topics include:
•
compliance to European Union Directives
•
hardware overview
•
master control relay
•
surge suppressors
•
safety considerations
•
power considerations
•
preventing excessive heat
•
controller spacing
•
mounting the controller
If this product has the CE mark it is approved for installation within the
European Union and EEA regions. It has been designed and tested to meet
the following directives.
EMC Directive
This product is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) and the following standards, in whole
or in part, documented in a technical construction file:
•
EN 50081-2
EMC – Generic Emission Standard, Part 2 – Industrial Environment
•
EN 50082-2
EMC – Generic Immunity Standard, Part 2 – Industrial Environment
This product is intended for use in an industrial environment.
Low Voltage Directive
This product is tested to meet Council Directive 73/23/EEC Low Voltage, by
applying the safety requirements of EN 61131–2 Programmable Controllers,
Part 2 – Equipment Requirements and Tests.
For specific information required by EN 61131-2, see the appropriate
sections in this publication, as well as the following Allen-Bradley
publications:
•
Industrial Automation Wiring and Grounding Guidelines For Noise
Immunity, publication 1770-4.1
•
Guidelines for Handling Lithium Batteries, publication AG-5.4
•
Automation Systems Catalog, publication B111
Compliance to European
Union Directives