Rockwell Automation 1336Z SPIDER - FRN 2.xxx-5.xxx - Manual (Page 50)

5–6 Human Interface Module
Control Status (except Series A HIMs below version 3.0)
Permits the drive logic mask to be disabled/enabled allowing HIM
removal while drive power is applied. Disabling the logic mask with a
Series A HIM below version 3.0 can be accomplished with [Logic
Mask] as explained on page 5–13. This menu also provides access to
a fault queue which will list the last four faults that have occurred.
“Trip” displayed with a fault indicates the actual fault that tripped the
drive. A clear function clears the queue - it will not clear an active
fault.
Password
The Password mode protects the drive parameters against programming
changes by unauthorized personnel. When a password has been
assigned, access to the Program/EEProm modes and the Control Logic/
Clear Fault Queue menus can only be gained when the correct
password has been entered. The password can be any five digit number
between 00000 and 65535. Refer to the example on page 5–13.
Figure 5.4
HIM Programming Steps
Choose Mode
Display
Choose Mode
Program
Choose Mode
Start Up 1
Choose Mode
Password
Choose Mode
EEPROM
Choose Mode
Search 1
Choose Mode
Control Status 1
Login, Logout
Modify
Parameter Groups
(See Chapter 7)
Parameters
(See Chapter 7)
Choose Mode
Process
Process Display Save Values 3
Recall Values 3
Reset Defaults
HIM -> Drive 2
Drive -> HIM 2
OPERATOR LEVEL
MODE LEVEL
GROUP LEVEL
PARAMETER LEVEL
Control Logic,
Fault Queue
1 Not available on Series A HIMs (below version 3.0).
Power-Up Mode &
Status Display
ESC SEL
or or or or
(Read Only) (Read Only) (Read/Write)
2 Not available on all HIMs – Refer to Table 3.A. 3 Reserved for future use.