Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 292)

292 Rockwell Automation Publication 280E-UM001B-EN-P – July 2012
Appendix B CIP Information
Discrete Input Group Object CLASS CODE 0x001D
No class attributes will be supported for the Discrete Input Group Object.
A single instance of the Discrete Input Group Object is supported and contains
the following instance attributes.
The following common services will be implemented for the Discrete Input
Group Object.
Discrete Output Group Object CLASS CODE 0x001E
No class attributes will be supported for the Discrete Output Group Object.
Instance 1 exists for all ArmorStart units. Instance 2 exists for drive units only.
Instances 1 contains the following instance attributes.
Attribute ID Access Rule Name Data Type Value
3 Get Number of Instances USINT 4
4 Get Binding Array of UINT List of DIP Instances
6 Get/Set Off_On_Delay UINT —
7 Get/Set Off_On_Delay UINT —
Service Code
Implemented for:
Service Name Class Instance
0x0E No Yes Get_Attribute_Single
0x10 No Yes Set_Attribute_Single
Attribute ID Access Rule Name Data Type Value
3 Get Number of Instances USINT 4 for DOL/Soft Starter 10 for Inverters
4 Get Binding Array of UINT List of DOP Instances
6 Get/Set Command BOOL 0 = Idle, 1 = Run
104 Get/Set Network Status Overrride BOOL
0 = No Override (go to safe state)
1 = Override (run local logic)
105 Get/Set Comm Status Overrride BOOL
0 = No Override (go to safe state)
1 = Override (run local logic)