Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 282)

282 Rockwell Automation Publication 280E-UM001B-EN-P – July 2012
Appendix B CIP Information
I/O Assemblies
The following table summarizes the Assembly instances that are supported in the
ArmrorStart EtherNet/IP Product:
➊ These assemblies are selectable on Inverter Type ArmorStart units only.
Instances 3 and 52 are required by the ODVA Motor Starter Profile. When used
as an EtherNet/IP Class 1 connection point, the I/O data attribute is simply
passed through the bridge.
Instance 3
This is the required output (consumed) assembly.
Instance 52
This is the required input (produced) assembly.
Instance Type Description
3 Consumed Required ODVA Consumed Instance
52 Produced Required ODVA Produced Instance
150 Produced Default Bulletin 280E/281E Produced Assembly
151 ➊ Produced Default Bulletin 284E Produced Assembly
162 Consumed Default Consumed Instance for DOL and Reversing Starters
166 ➊ Consumed Default Consumed Instance for Inverter type Starters
191 Consumed Empty assembly for Input Only I/O Connection
192 Consumed Empty assembly for Listen Only I/O Connection
Instance 3 ODVA Starter
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 — — — — — — — Run Fwd
Instance 52 ODVA Starter
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
— — — — — — Running — Fault