Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 123)

Rockwell Automation Publication 280E-UM001B-EN-P – July 2012 123
Bulletin 280E/281E/284E Programmable Parameters Chapter 7
Starter Protection Group
Int03DeviceOut Cfg
This parameter is used to specify
Int03DeviceOut of produced assembly
150 or 151.
Parameter Number 16
Access Rule GET/SET
Data Type USINT
Group Produced Assembly Config
Units —
Minimum Value 0
Maximum Value 108
Default Value 6
Pr FltReset Mode
This parameter configures the
Protection Fault reset mode.
0 = Manual
1 = Automatic
Parameter Number 23
Access Rule GET/SET
Data Type BOOL
Group Starter Protection
Units —
Minimum Value 0
Maximum Value 1
Default Value 0
Pr Fault Enable
This parameter enables the Protection
Fault by setting the bit
to 1.
Parameter Number 24
Access Rule GET/SET
Data Type WORD
Group Starter Protection
Units —
Minimum Value 12419
Maximum Value 13287
Default Value 12419