Rockwell Automation 20-COMM-ER 20-COMM-ER Dual-Port EtherNet/IP Communication Adapter User Manual - Manual (Page 33)

Rockwell Automation Publication 20COMM-UM015B-EN-P - July 2013 33
Configuring the Adapter Chapter 3
2. Set the value of Parameters 04 - [IP Addr Cfg 1] through 07 - [IP Addr
Cfg 4]
to a unique IP address.
3. Reset the adapter; see Resetting the Adapter on page 43 .
The Network status indicator will be steady green or flashing green if
the IP address is correctly configured, and is connected to an operating
ethernet network.
Set a Subnet Mask Using Parameters
1. Verify that Parameter 03 - [BOOTP/DHCP] is set to ‘0’ (Disabled).
2. Set the value of Parameters 08 - [Subnet Cfg 1] through 11 - [Subnet Cfg
4]
to the desired value for the subnet mask.
3. Reset the adapter; see Resetting the Adapter on page 43 .
Set a Gateway Address Using Parameters
1. Verify that Parameter 03 - [BOOTP] is set to ‘0’ (Disabled).
2. Set the value of Parameters 12 - [Gateway Cfg 1] through 15 - [Gateway
Cfg 4]
to the IP address of the gateway device.
3. Reset the adapter; see Resetting the Adapter on page 43 .
Port 5 Device
20-COMM-ER
Parameter #: 04
IP Addr Cfg 1
0
0 <> 255
Default = 0.0.0.0 255.255.255.255
[IP Addr Cfg 1]
[IP Addr Cfg 2]
[IP Addr Cfg 3]
[IP Addr Cfg 4]
Port 5 Device
20-COMM-ER
Parameter #: 08
Subnet Cfg 1
0
0 <> 255
Default = 0.0.0.0 255.255.255.255
[Subnet Cfg 1]
[Subnet Cfg 2]
[Subnet Cfg 3]
[Subnet Cfg 4]
Port 5 Device
20-COMM-ER
Parameter #: 12
Gateway Cfg 1
0
0 <> 255
Default = 0.0.0.0 255.255.255.255
[Gateway Cfg
[Gateway Cfg 2]
[Gateway Cfg 3]
[Gateway Cfg 4]