Rockwell Automation 20-COMM-ER 20-COMM-ER Dual-Port EtherNet/IP Communication Adapter User Manual - Manual (Page 163)

Rockwell Automation Publication 20COMM-UM015B-EN-P - July 2013 163
Viewing the Adapter Web Pages Chapter 8
Figure 93 - Example of Selected Faults Configuration Page
c. Click the desired fault/alarm check boxes.
d. Click Apply Changes.
e. Click the ‘Back to E-mail Configuration Page’ link.
2. Type the following information in their respective boxes.
Figure 94 shows an example email message automatically sent by the adapter in
response to selected events.
Figure 94 - Example of E-mail Message Sent by the Adapter
Information Description
‘SMTP Server’ Type in the address of the mail server that will be used to deliver
the email messages. (When the IP address is unknown, read the
TIP shown below this table to determine the mail server address.)
‘TO email recipient’ Type in addresses to where you want email messages to be sent.
Multiple addresses can be used, but they must be separated by
commas (comma delimited).
‘Subject of e-mail message…’ Type in the desired subject text for the email message.