Rockwell Automation 20-COMM-ER 20-COMM-ER Dual-Port EtherNet/IP Communication Adapter User Manual User Manual
Page 14
14
Rockwell Automation Publication 20COMM-UM015B-EN-P - July 2013
Chapter 1 Getting Started
– Connected Components Workbench software, version 1.02 or later
Connected Components Workbench is the recommended stand-alone
software tool for use with PowerFlex drives. You can obtain a free copy
by:
• Internet download at
• Requesting a DVD at
Your local distributor may also have copies of the DVD available.
Connected Components Workbench software cannot be used to
configure SCANport-based drives or Bulletin 160 drives.
– DriveExplorer software, version 2.01 or later
This software tool has been discontinued and is now available as
freeware
at
. There
are no plans to provide future updates to this tool and the download is
being provided ‘as-is’ for users that lost their DriveExplorer CD, or need
to configure legacy products not supported by Connected Components
Workbench software.
– DriveExecutive software, version 3.01 or later
A Lite version of DriveExecutive software ships with RSLogix 5000,
RSNetWorx MD, FactoryTalk AssetCentre, and ItelliCENTER
software. All other versions are purchasable items:
• 9303-4DTE01ENE Drive Executive software
• 9303-4DTS01ENE DriveTools SP Suite (includes DriveExecutive
and DriveObserver software)
• 9303-4DTE2S01ENE DriveExecutive software upgrade to
DriveTools SP Suite (adds DriveObserver software)
DriveExecutive software updates (patches, and so forth) can be obtained
at
t is
highly recommended that you periodically check for and install the latest
update.
– BOOTP server, version 2.1 or higher, for network setup only
❑ Controller configuration software, such as RSLogix 5/500/5000
❑ A computer connection to the EtherNet/IP network