Rockwell Automation 20-COMM-ER 20-COMM-ER Dual-Port EtherNet/IP Communication Adapter User Manual - Manual (Page 25)

Rockwell Automation Publication 20COMM-UM015B-EN-P - July 2013 25
Installing the Adapter Chapter 2
Table 1 - Drive and Adapter Start-Up Status Indications
After verifying correct operation, close or install the drive cover. For more details
on status indicator operation, see
page 144 and page 145 .
Item Name Color State Description
Drive STS Indicator
➊ STS (Status)
refer to drive
or SMC
manual for
status
indication
information)
Green Flashing Device ready but not running, and no faults are present.
Steady Device running, no faults are present.
Yellow Flashing,
device stopped
An inhibit condition exists – the drive cannot be started. Check device Parameter 214 - [Start
Inhibits].
Flashing,
device running
An intermittent type 1 alarm condition is occurring. Check device Parameter 211 - [Drive Alarm 1].
Steady,
device running
A continuous type 1 alarm condition exists. Check device Parameter 211 - [Drive Alarm 1].
Red Flashing A fault has occurred.
Steady A non-resettable fault has occurred.
Adapter Status Indicators
➋ PS Off Steady No power
Orange Flashing Requesting DPI I/O Connections
Steady Peripheral is Connected to an incompatible product or no DPI ping events are detected.
Green Flashing Normal Operation (DPI connected) - No I/O, or PLC in Program
Steady Normal Operation (DPI connected) - I/O Operational
Red Flashing DPI Problem, Bad CRC of Adapter Parameters or Flash Program
Steady DPI Failure or Failed power-on diagnostic test (hardware failure)
Green/
Red
Flashing Flash update in progress
NS Off Steady No power OR no IP Address
Green Flashing An IP address is configured, but no CIP connections are established, and an Exclusive Owner
connection has not timed out
Steady At least one CIP connection (any transport class) is established, and an Exclusive Owner
connection has not timed out
Red Flashing Connection has timed out see the “The EtherNet Adaptation of CIP” Specification sections 9-4.4
for detailed behavior description
Steady Duplicate IP Address detected
Orange Steady Adapter Failure (used in conjunction with PS orange)
Green/
Red
Flashing Self-test on power up
LS1 Off Steady No Network Activity
Green Flashing Network activity at 100 Mbps
Yellow Flashing Network activity at 10 Mbps
LS2 Off Steady No Network Activity
Green Flashing Network activity at 100 Mbps
Yellow Flashing Network activity at 10 Mbps