Rockwell Automation 20-COMM-ER 20-COMM-ER Dual-Port EtherNet/IP Communication Adapter User Manual User Manual
Dual-port ethernet/ip communication adapter
Table of contents
Document Outline
- Dual-Port EtherNet/IP Communication Adapter
- Table of Contents
- Preface
- 1- Getting Started
- 2-Installing the Adapter
- 3-Configuring the Adapter
- Configuration Tools
- Using the PowerFlex 7- Class HIM
- Using BOOTP
- Setting the IP Address, Subnet Mask, and Gateway Address
- Setting the Data Rate
- Setting the I/O Configuration
- Selecting Master-Slave or Peer-to-Peer
- Setting the Reference Adjustment
- Setting a Fault Action
- Setting Web Access Control
- Resetting the Adapter
- Viewing the Adapter Status Using Parameters
- Updating the Adapter Firmware
- 4-Configuring the I/O
- Using RSLinx Classic Software
- ControlLogix Controller Example
- Limitations Using a MicroLogix 1100/1400 Controller
- MicroLogix 1100/1400 Controller Example
- 5-Using the I/O
- About I/O Messaging
- Understanding the I/O Image
- Using Logic Command/ Status
- Using Reference/Feedback
- Using Datalinks
- Example Ladder Logic Program Information
- ControlLogix Controller Example
- MicroLogix 1100/1400 Controller Example
- 6-Using Explicit Messaging
- About Explicit Messaging
- Performing Explicit Messages
- ControlLogix Controller Examples
- Explicit Messaging Using RSLogix 5000 Software, Version 15.00 or Later
- ControlLogix Controller Example Ladder Logic Program to Read a Single Parameter
- ControlLogix Controller – Formatting a Message to Read a Single Parameter, RSLogix 5000 Software, Version 15.00 or Later
- ControlLogix Controller Example Ladder Logic Program to Write a Single Parameter, RSLogix 5000 Software, Version 15.00 or Later
- ControlLogix Controller – Formatting a Message to Write a Single Parameter, RSLogix 5000 Software, Version 15.00 or Later
- ControlLogix Controller Example Ladder Logic Program to Read Multiple Parameters, RSLogix 5000 Software, All Versions
- ControlLogix Controller – Formatting a Message to Read Multiple Parameters, RSLogix 5000 Software, All Versions
- ControlLogix Controller Example Scattered Read Request Data
- ControlLogix Controller Example Scattered Read Response Data
- ControlLogix Controller Example Ladder Logic Program to Write Multiple Parameters, RSLogix 5000 Software, All Versions
- ControlLogix Controller – Formatting a Message to Write Multiple Parameters, RSLogix 5000 Software, All Versions
- ControlLogix Controller Example Scattered Write Request Data
- ControlLogix Controller Example Scattered Write Response Data
- ControlLogix Controller – Explanation of Request and Response Data for Read/Write Multiple Messaging, RSLogix 5000 Software, All Versions
- Explicit Messaging Using RSLogix 5000 Software, All Versions
- ControlLogix Controller Example Ladder Logic Program to Read a Single Parameter
- ControlLogix Controller – Formatting a Message to Read a Single Parameter, RSLogix 5000 Software, All Versions
- ControlLogix Controller Example Ladder Logic Program to Write a Single Parameter, RSLogix 5000 Software, All Versions
- ControlLogix Controller – Formatting a Message to Write a Single Parameter, RSLogix 5000 Software, All Versions
- ControlLogix Controller Example Ladder Logic Program to Read or Write Multiple Parameters, RSLogix 5000 Software, All Versions
- Explicit Messaging Using RSLogix 5000 Software, Version 15.00 or Later
- MicroLogix 1100/1400 Controller Examples
- MicroLogix 1100/1400 Controller Explicit Messaging Using the Read/Write Parameter Service
- MicroLogix 1100/1400 Controller Example Ladder Logic Program to Read a Single Parameter
- MicroLogix 1100/1400 Controller – Formatting a Message to Read a Single Parameter Using Read/Write Parameter Service
- MicroLogix 1100/1400 Controller Example Read Single Response Data
- MicroLogix 1100/1400 Controller Example Ladder Logic Program to Write a Single Parameter Using Read/Write Parameter Service
- MicroLogix 1100/1400 Controller – Formatting a Message to Write a Single Parameter Using Read/Write Parameter Service
- MicroLogix 1100/1400 Controller Example Write Single Request Data
- MicroLogix 1100/1400 Controller Explicit Messaging Using the Generic Get/Set Attribute Service
- MicroLogix 1100/1400 Controller Example Ladder Logic Program to Read a Single Parameter
- MicroLogix 1100/1400 Controller – Formatting a Message to Read a Single Parameter Using Generic Get/Set Attribute Service
- MicroLogix 1100/1400 Controller Example Get Attribute Single Response Data
- MicroLogix 1100/1400 Controller Example Ladder Logic Program to Write a Single Parameter Using Generic Get/Set Attribute Service
- MicroLogix 1100/1400 Controller – Formatting a Message to Write a Single Parameter Using Generic Get/Set Attribute Service
- MicroLogix 1100/1400 Controller Example Set Attribute Single Request Data
- MicroLogix 1100/1400 Controller Example Ladder Logic Program to Read Multiple Parameters Using Generic Get/Set Attribute Service
- MicroLogix 1100/1400 Controller – Formatting a Message to Read Multiple Parameters Using Generic Get/Set Attribute Service
- MicroLogix 1100/1400 Controller Example Scattered Read Request Data
- MicroLogix 1100/1400 Controller Example Scattered Read Response Data
- MicroLogix 1100/1400 Controller Example Ladder Logic Program to Write Multiple Parameters Using Generic Get/Set Attribute Service
- MicroLogix 1100/1400 Controller – Formatting a Message to Write Multiple Parameters Using Generic Get/Set Attribute Service
- MicroLogix 1100/1400 Controller Example Scattered Write Request Data
- MicroLogix 1100/1400 Controller Example Scattered Write Response Data
- MicroLogix 1100/1400 Controller – Explanation of Request and Response Data for Read/Write Multiple Messaging
- MicroLogix 1100/1400 Controller Explicit Messaging Using the Read/Write Parameter Service
- 7-Troubleshooting
- 8-Viewing the Adapter Web Pages
- 9-Using the Adapter in a DPI External Comms Kit (20-XCOMM-DC-BASE)
- A-Specifications
- B-Adapter Parameters
- C-EtherNet/IP Objects
- Supported Data Types
- Identity Object
- Assembly Object
- Register Object
- Parameter Object
- Parameter Group Object
- Device Level Ring Object
- Quality of Service Object
- PCCC Object
- DPI Device Object
- DPI Parameter Object
- DPI Fault Object
- DPI Alarm Object
- DPI Diagnostic Object
- DPI Time Object
- TCP/IP Interface Object
- Ethernet Link Object
- D-Logic Command/Status Words
- Glossary
- Index
- Back Cover