Rockwell Automation 20-COMM-ER 20-COMM-ER Dual-Port EtherNet/IP Communication Adapter User Manual - Manual (Page 27)

Rockwell Automation Publication 20COMM-UM015B-EN-P - July 2013 27
Chapter
3
Configuring the Adapter
This chapter provides instructions and information for setting the parameters in
the adapter.
For a list of parameters, see Appendix B , Adapter Parameters . For definitions of
terms in this chapter, see the .
Configuration Tools
The adapter stores parameters and other information in its own nonvolatile
storage (NVS) memory. You must, therefore, access the adapter to view and edit
its parameters. The following tools can be used to access the adapter parameters.
Topic Page
Configuration Tools 27
Using the PowerFlex 7-Class HIM 28
Using BOOTP 29
Setting the IP Address, Subnet Mask, and Gateway Address 32
Setting the Data Rate 34
Setting the I/O Configuration 35
Selecting Master-Slave or Peer-to-Peer 36
Setting the Reference Adjustment 41
Setting a Fault Action 41
Setting Web Access Control 42
Resetting the Adapter 43
Viewing the Adapter Status Using Parameters 44
Updating the Adapter Firmware 44
Tool See
PowerFlex 7-Class HIM page 28
BOOTP/DHCP server page 29
Connected Components Workbench
software, version 1.02 or later
http://www.ab.com/support/abdrives/webupdate/
software.html , or online help (installed with the software)