C105, Communications group (continued) – Rockwell Automation 22C PowerFlex 400 AC Drive FRN 1.xx - 7.xx User Manual
Page 90

3-32
Programming and Parameters
PowerFlex 400 Adjustable Frequency AC Drive FRN 1.xx - 7.xx User Manual
Publication 22C-UM001I-EN-P
Communications Group (continued)
C104 [Comm Node Addr]
Related Parameter(s):
Sets the drive node address for the RS485 (DSI) port if using a network connection.
Important: Power to drive must be cycled before any changes will affect drive operation.
Values
Default:
100
Min/Max:
1/247
Display:
1
C105 [Comm Loss Action]
Selects the drive’s response to a loss of the communication connection or excessive communication
errors.
Options
0 “Fault” (Default)
Drive will fault on an F81 Comm Loss and coast to stop.
1 “Coast Stop”
Stops drive via coast to stop.
2 “Stop”
Stops drive via
3 “Continu Last”
Drive continues operating at communication commanded
speed saved in RAM.
4 “Run Preset 0”
Drive will run at preset speed.
5 “Kypd Inc/Dec”
Drive will run at keypad (digital pot) speed
C106 [Comm Loss Time]
Related Parameter(s):
Sets the time that the drive will remain in communication loss before implementing the option selected
in
Values
Default:
5.0 Secs
Min/Max:
0.1/60.0 Secs
Display:
0.1 Secs
C107 [Comm Write Mode]
Determines whether parameter changes made over communication port are saved and stored in
Non-Volatile Storage (NVS) or RAM only. If they are stored in RAM, the values will be lost at
power-down.
Options
0 “Save” (Default)
1 “RAM Only”
ATTENTION:
Risk of equipment damage exists. If a controller is programmed to
write parameter data to Non-Volatile Storage (NVS) frequently, the NVS will quickly
exceed its life cycle and cause the drive to malfunction. Do not create a program that
frequently uses configurable outputs to write parameter data to NVS unless C107
[Comm Write Mode] is set to option 1.