Lenze PLC Designer R3-x - Manual (Page 8)

About this documentation
8
Lenze · Commissioning of Lenze drives · 1.3 EN - 06/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1 About this documentation
This documentation describes the first commissioning steps of a Lenze automation system on the
basis of predefined sample projects. The automation system used consists of a PLC for the control
technology and drive components connected (via a bus system).

Tip!
Current information and tools regarding the Lenze products can be found in the download
area at: http://www.Lenze.com
This manual is part of the "Controller-based Automation" manual collection. The manual collection
consists of the documents:

Read the mounting instructions accompanying the controller first before you start
working!
The mounting instructions include safety instructions which must be observed!

Note!
This documentation supplements the software manuals of the »PLC Designer« and
»Engineer«.
Type of documentation Subject
System manuals System overview/example topologies
• Controller-based Automation
• Visualisation
Communication manuals Bus systems
• Controller-based Automation EtherCAT®
• Controller-based Automation CANopen®
• Controller-based Automation PROFIBUS®
• Controller-based Automation PROFINET®
Online helps/
software manuals
Lenze Engineering tools
• »PLC Designer«: Programming
• »Engineer«: Configuration of drives
• »VisiWinNET® Smart«: Visualisation
• »Backup & Restore«: Backing up/restoring data