Lenze PLC Designer R3-x - Manual (Page 47)

Lenze · Commissioning of Lenze drives · 1.3 EN - 06/2014
47
Working with the sample projects
Sample project with "Table positioning" application - TablePositioning
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.2.6.3 Manual mode ("Manual jog")
The controller can be actuated manually via the visualisation of the L_LCB_TablePositioning block.
• Button  selects the manual (manual jog) mode.
• The control and status panel  contains the FB for actuating the controller.
• The controller can be actuated manually via the visualisation of the L_LCB_TablePositioning
block.
Note: Activate button  to be able to operate the controller via the visualisation.
• Enable the controller via the xDriveEnable FB input to be able to define setpoints manually.
Note: Click the xDriveSetQsp button to activate quick stop.
Further information on the FB can be found in the following section:
 L_LCB_TablePositioning ( 120)
• Area  visualises the FB for reading out the errors from the controller.
Further information on the FB can be found in the following section:
 L_DCO_ReadDriveParameter ( 105)
 Select mode Control/status panel Activate control via visualisation