Lenze PLC Designer R3-x - Manual (Page 21)

Lenze · Commissioning of Lenze drives · 1.3 EN - 06/2014
21
Which Lenze application samples (AppSamples) exist?
Controller-based Automation: Application samples
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6 Which Lenze application samples (AppSamples) exist?
The ready-configured sample projects are to facilitate the work with the Lenze products for
you. They include established system configurations representing typical application
cases. The objective is to obtain an executable Lenze automation system by using low
effort.
Depending on the application case, the sample projects can be optionally extended, and
thus they have to be adapted to the requirements in each case.
6.1 Controller-based Automation: Application samples
Product/device
application
Project name Available for
bus system
Lenze Engineering tool
»PLC Designer«
V3.x
»Engineer«
V2.x
Inverter Drives 8400
Baseline
Actuating drive
speed
LAS_40_INTF_Can_84BL_Speed_0100 CAN  
Stateline
Actuating drive
speed
LAS_40_INTF_Can_84SL_Speed_0200 CAN  
LAS_40_INTF_ETC_84SL_Speed_0100 EtherCAT  
HighLine
Table
positioning
LAS_40_INTF_Can_84HL_TabPos_0200 CAN  
LAS_40_INTF_ETC_84HL_TabPos_0100 EtherCAT  
Servo Drives 9400
HighLine
Actuating drive
speed
LAS_40_INTF_Can_94HL_Speed_0200 CAN  
LAS_40_INTF_ETC_94HL_Speed_0100 EtherCAT  
Table
positioning
LAS_40_INTF_Can_94HL_TabPos_0200 CAN  
LAS_40_INTF_ETC_94HL_TabPos_0100 EtherCAT  