For descriptions – ADC Soneplex Broadband System User Manual
Page 327
ADCP-61-471 • Issue 4 • June 2000 • Section 2: Operation and Maintenance
2-304
© 2000, ADC Telecommunications, Inc.
TAP-102
Page 5 of 11
Table 102-2. HDSL Mon Type Descriptions
MON TYPE
MEANING
LOCATION
DESCRIPTION
FCP
Failure Count Path
NEND, FEND, REPC,
REPR, CRP, RRP*
Count of Loss Of Sync Word (LOSW)
failures on the HDSL loop.
CVP
Code Violation Path
NEND, FEND, REPC,
REPR, CRP, RRP
Count of CRC errors on the HDSL loop.
ESP
Errored Second Path
NEND, FEND, REPC,
REPR, CRP, RRP
A second in which one or more CRC
errors occurred on the HDSL loop, and
no LOSW defects occurred.
SESP
Severely Errored
Second Path
NEND, FEND, REPC,
REPR, CRP, RRP
A second in which the number of CRC
errors on the HDSL loop was greater
than or equal to some user-specified
value, and no LOSW defects occurred.
SEFSP
Severely Errored
Framing Second Path
NEND, FEND, REPC,
REPR, CRP, RRP
A second in which one or more LOSW
defects occurred on the HDSL loop.
PA-H
Pulse Attenuation
–
High Path
NEND, FEND, REPC,
REPR, CRP, RRP
Highest Pulse Attenuation value detected
on the HDSL loop within the interval.
This value is only updated when the
HDSL loop is active. If the HDSL loop
has never been activated, this value will
be set to 0.
SNR-L
Signal-to-Noise Ratio
–
Low Path
NEND, FEND, REPC,
REPR, CRP, RRP
Lowest SNR detected on the HDSL loop
within the interval. This value is only
updated when the HDSL loop is active.
If the HDSL loop has never been
activated, this value will be set to 71.
* For descriptions of locations where thresholds are monitored (such as FEND, NEND, REPC, REPR,
CRP, and RRP), refer to