Allied Telesis AT-S63 - Manual (Page 96)

Chapter 6: Enhanced Stacking Commands
96
ACCESS SWITCH
Syntax
access switch number= number |macaddress= macaddress
Parameters
number Specifies the number of the switch in an enhanced
stack that you want to manage. You view this number
using the SHOW REMOTELIST command.
macaddress Specifies the MAC address of the switch you want to
manage. This can also be displayed using the SHOW
REMOTELIST command. You can enter the address
in either of the following formats:
xxxxxxxxxxxx or xx:xx:xx:xx:xx:xx
Description
This command starts a management session on another switch that
supports enhanced stacking, such as another AT-9400 Series switch or an
AT-8000 Series switch. You can specify the switch by switch number or by
MAC address, both of which are displayed with “SHOW REMOTELIST” on
page 100.
Note
You must perform the ACCESS SWITCH command from a
management session of a master switch. This command will not
work from a management session of a slave switch. To determine
the master or slave status of your switch, use “SHOW SWITCH” on
page 62.
Note
You must perform the SHOW REMOTELIST command before using
the ACCESS SWITCH command.
When you are finished managing a slave switch, use the LOGOFF,
LOGOUT, or QUIT commands to end the management session and return
back to the master switch from which you started the management
session. For information, refer to “LOGOFF, LOGOUT and QUIT” on
page 25.