Allied Telesis AT-S63 - Manual (Page 301)

AT-S63 Management Software Command Line Interface User’s Guide
301
ADD SNMPV3 USER
Syntax
add snmpv3 user= user [authentication=md5|sha]
authpassword =password privpassword =password
[storagetype=volatile|nonvolatile]
Parameters
user Specifies the name of an SNMPv3 user, up to 32
alphanumeric characters.
authentication Specifies the authentication protocol that is used to
authenticate this user with an SNMP entity
(manager or NMS). If you do not specify an
authentication protocol, this parameter is
automatically set to None. The options are:
md5 The MD5 authentication protocol. SNMPv3 Users
are authenticated with the MD5 authentication
protocol after a message is received.
sha The SHA authentication protocol. Users are
authenticated with the SHA authentication protocol
after a message is received.
Note: You must specify the authentication protocol
before you specify the authentication password.
authpassword Specifies a password for the authentication
protocol, up to 32 alphanumeric characters. If you
specify an authentication protocol, then you must
configure an authentication protocol password.
privpassword Specifies a password for the 3DES privacy, or
encryption protocol, up to 32 alphanumeric
characters. This is an optional parameter.
Note: If you specify a privacy password, the privacy
protocol is set to DES. You must also specify an
authentication protocol and password.
storagetype Specifies the storage type of this table entry. This is
an optional parameter. The options are:
volatile Does not allow you to save the table entry to the
configuration file on the switch. This is the default.
nonvolatile Allows you to save the table entry to the