Allied Telesis AT-S63 - Manual (Page 430)

Chapter 27: GARP VLAN Registration Protocol Commands
430
DISABLE GARP
Syntax
disable garp=gvrp [gip]
Parameters
garp Specifies the GARP application you want to disable.
The only GARP application supported by AT-S63
management software is GVRP.
gip Disables GARP Information Propagation (GIP).
Note
The online help for this command contains an STP option. The
option is not supported.
Description
This command disables GVRP on the switch. After disabled, the switch
will not learn any new dynamic GVRP VLANs or dynamic GVRP ports.
You can also use this command to disable GIP.
Note
Do not disable GIP if the switch is running GVRP. GIP is required for
proper GVRP operation.
Examples
The following command disables GVRP on the switch:
disable garp=gvrp
The following command disables GIP only:
disable garp=gvrp gip