Allied Telesis AT-S63 - Manual (Page 136)

Chapter 10: LACP Commands
136
ADD LACP PORT
Syntax
add lacp port= port aggregator= name priority= priority
adminkey= key
Parameters
port Specifies the port to be added to the aggregator. You
can add more than one port at a time. You can specify
the ports individually (for example, 5,7,22), as a range
(for example, 18-20), or both (for example, 1,14-16).
aggregator Specifies the name of the aggregator.
priority The priority level of the port, a hexadecimal number
between 0x1 and 0xffff. The lower the number, the
higher the priority.
adminkey Specifies the ID for the aggregator, a hexadecimal
number between 0x1 and 0xffff.
Description
This command adds ports to an existing aggregator. If the aggregator is
not specified, the ports are associated with the aggregator of the lowest
numbered port. If the admin key is not specified, the admin key of the first
port is used to associate these ports. To initially create an aggregator,
refer to “CREATE LACP AGGREGATOR” on page 137.
Example
The following command adds ports 8 and 22 to the aggregator named
AGG_1:
add lacp port=8,22 aggregator=AGG_1