Allied Telesis AT-S63 - Manual (Page 283)

AT-S63 Management Software Command Line Interface User’s Guide
283
SET QOS COSP
Syntax
set qos cosp= priority-number qid= queue-number
Parameters
cosp Specifies the Class of Service (CoS) priority level. The CoS
priority levels are 0 through 7, with 0 as the lowest priority
and 7 as the highest. You can specify more than one
priority to assign to the same egress queue.
qid Specifies the egress queue number. The egress queues
are numbered 0 through 7, with queue 0 as the lowest
priority and 7 as the highest.
Description
This command maps CoS priorities to port egress queues. You must
specify both the priority and the queue ID. You can assign more than one
priority to an egress queue. Table 6 on page 280 lists the default
mappings between the eight CoS priority levels and the eight egress
queues of a switch port.
Note
This command is equivalent to “MAP QOS COSP” on page 280.
Example
The following command maps priorities 5 and 6 to egress queue 1:
set qos cosp=5,6 qid=1