Allied Telesis AT-S63 - Manual (Page 433)

AT-S63 Management Software Command Line Interface User’s Guide
433
SET GARP PORT
Syntax
set garp=gvrp port= port mode=normal|none
Parameters
garp Specifies the GARP application you want to
configure. The only GARP application supported by
AT-S63 management software is GVRP.
port Specifies the port you want to configure on the switch.
You can specify more than one port at a time.
mode Specifies the GVRP mode of the port. Modes are:
normal The port will participate in GVRP. The
port will process GVRP information and
transmit PDUs. This is the default.
none The port will not participate in GVRP.
The port will not process GVRP
information nor transmit PDUs.
Note
The online help for this command contains an STP option. This
option is not supported.
Description
This command sets a port’s GVRP status. If you want a port to learn
remote VLANs and transmit PDUs, set its mode to Normal. If you do not
want a port to participate in GVRP, set its mode to None.
Examples
The following command sets ports 1 to 4 to not participate in GVRP:
set garp=gvrp port=1-4 mode=none
The following command activates GVRP on port 3:
set garp=gvrp port=3 mode=normal