Allied Telesis AT-S63 - Manual (Page 467)

AT-S63 Management Software Command Line Interface User’s Guide
467
identified by the switch by using
the client's MAC address. This
is the default setting.
authorised or Disables 802.1X port-based
forceauthenticate authentication and causes the
port to transition to the
authorized state without any
authentication exchange
required. The port transmits
and receives normal traffic
without 802.1X-based
authentication of the client. The
parameters are equivalent.
unauthorised or Causes the port to remain in
forceunauthenticate the unauthorized state,
ignoring all attempts by the
client to authenticate. The
switch cannot provide
authentication services to the
client through the interface. The
parameters are equivalent.
quietperiod Sets the number of seconds that the switch remains in
the quiet state following a failed authentication
exchange with the client. The default value is 60
seconds. The range is 0 to 65,535 seconds.
txperiod Sets the number of seconds that the switch waits for a
response to an EAP-request/identity frame from the
client before retransmitting the request. The default
value is 30 seconds. The range is 1 to 65,535 seconds.
reauthperiod Enables periodic reauthentication of the client, which is
disabled by default. The default value is 3600 seconds.
The range is 1 to 65,535 seconds.
supptimeout Sets the switch-to-client retransmission time for the
EAP-request frame. The default value for this
parameter is 30 seconds. The range is 1 to 600
seconds.
servertimeout Sets the timer used by the switch to determine
servtimeout authentication server timeout conditions. The default
value is 10 seconds. The range is 1 to 60 seconds. The
parameters are equivalent.
maxreq Specifies the maximum number of times that the switch
retransmits an EAP Request packet to the client before
it times out the authentication session. The range is 1 to