Allied Telesis AT-S63 - Manual (Page 113)

AT-S63 Management Software Command Line Interface User’s Guide
113
parameter. The options are:
yes, on, true Overrides the priority level in
tagged packets. The options are
equivalent.
no, off, false Does not override the priority in
tagged packets. The options are
equivalent.
priority Specifies the port’s priority level. All ingress
untagged packets will be stored in the egress
queue on the egress port that corresponds to
the priority level specified with this parameter. If
you include the OVERRIDEPRIORITY
parameter, this will also apply to all ingress
tagged packets. The range is 0 to 7; 0 is the
lowest priority, and 7 is the highest. The default
is 0.
renegotiation Prompts the port to renegotiate its speed and
duplex mode with the end node. This parameter
only works when the port is using
autonegotiation. The only option is:
auto Renegotiates speed and duplex
mode with the end node.
softreset Resets the port. This parameter does not
change any of a port’s operating parameters.
speed Sets the speed and duplex mode of the port.
The options are:
autonegotiate The port autonegotiates both
speed and duplex mode. This is
the default setting.
10mhalf 10 Mbps and half-duplex mode.
10mfull 10 Mbps and full-duplex mode.
100mhalf 100 Mbps and half-duplex mode.
100mfull 100 Mbps and full-duplex mode.
Note
A speed of 1000 Mbps is only available when you set the port to
autonegotiate.