Allied Telesis AT-S63 - Manual (Page 137)

AT-S63 Management Software Command Line Interface User’s Guide
137
CREATE LACP AGGREGATOR
Syntax
create lacp aggregator= name port= port
[distribution=macsrc|macdest|macboth|ipsrc|ipdest|ipboth]
adminkey= key
Parameters
aggregator Specifies the name of the aggregator. The name can be
up to 20 alphanumeric characters. No spaces or special
characters are allowed.
port Specifies the port to be added to the aggregator. You
can add more than one port at a time. You can specify
the ports individually (for example, 5,7,22), as a range
(for example, 18-20), or both (for example, 1,14-16).
distribution Specifies the load distribution method, which can be
one of the following:
macsrc Source MAC address.
macdest Destination MAC address.
macboth Source address/destination MAC
address. This is the default.
ipsrc Source IP address.
ipdest Destination IP address.
ipboth Source address/destination IP
address.
adminkey Specifies the ID for the aggregator, a hexadecimal
number between 0x1 and 0xffff.
Description
This command creates an LACP aggregator. If you do not specify a
distribution method, the default method is macboth. If you do not specify
an admin key, the default admin key of the first port being added to this
aggregator is used.
Examples
The following command creates an LACP aggregator named “AGG_1”
containing ports 1 through 4 and operating with the source MAC address