Allied Telesis AT-S63 - Manual (Page 166)

Chapter 13: File System Commands
166
LOAD
Syntax
load method=[tftp|xmodem|local]
[srcfile=[flash:|cflash:]
filename |file=[flash:|cflash:]
filename ] destfile=appblock|[flash:|cflash:] filename
server= ipaddress
Parameters
method Specifies the download method. The options are:
tftp Specifies a TFTP download. To use this
option, there must be a network node with
TFTP server software. The file to download
onto the switch must be stored on the TFTP
server. You can use the TFTP option from
either a local or Telnet management
session.
xmodem Specifies an Xmodem download via a local
management session. This download
method is only available from a local
management session.
local Specifies a method to transfer an image into
the application block from flash memory or a
compact flash card.
srcfile or file Specifies the filename of the file you are downloading onto
the switch. The parameter is required for TFTP or local
download.
destfile Specifies the destination filename for the file. This is the
name under which the file is to be stored on the switch. The
name can be from 1 to 16 alphanumeric characters, not
including the three-letter extension. If the name includes
spaces, enclose it in double quotes. The options are:
appblock Specifies an image file download.
filename Specifies any file type.
server Specifies the IP address of network node containing the
TFTP server software. This parameter is required for a
TFTP download.