Allied Telesis AT-S63 - Manual (Page 199)

AT-S63 Management Software Command Line Interface User’s Guide
199
SET LOG OUTPUT
Syntax
set log log output= output-id destination= output-type
server= ipaddress
[facility=default|local1|local2|local3|local4|local5|local6
|local7] [syslogformat=extended|normal]
[severity=all|severity-list]
Parameters
output Specifies an ID number that identifies the output
definition. The possible output IDs are:
0 Permanent (nonvolatile) storage. You
cannot change or delete this ID.
1 Temporary (dynamic) storage. You
cannot change or delete this ID.
2 - 20 Available to be used for other outputs.
destination Specifies the destination for the log messages. The
only option currently supported is:
syslog Forwards log messages in syslog format
to a syslog server.
server Specifies the IP address of the syslog server.
facility Specifies the syslog facility levels for the generated
events. The default facilities are described in Table 3
on page 188.
local 1 through local 7
An identifier to assign to specific
switches or groups of switches.
severity Specifies the severity of events to be filtered. The
options are:
all Processes events of all severity levels.
This is the default.
severity Processes events of a particular severity
level. Choices are I for Informational, E
for Error, W for Warning, and D for
Debug. You can select more than one
severity at a time, for example E,W. For