Allied Telesis AT-S63 - Manual (Page 148)

Chapter 11: Port Mirroring Commands
148
SET SWITCH MIRROR
Syntax
set switch mirror= port
Parameter
mirror Specifies the destination port for the port mirror. This is the port
to where the traffic from the source ports will be copied. You
can specify only one port as the destination port. Specifying “0”
(zero) disables port mirroring.
Description
This command enables mirroring and specifies the destination port, or
disables mirroring. To select the source ports, refer to “SET SWITCH
PORT MIRROR” on page 149.
Note
When a transceiver is inserted into an uplink slot and a link is
established, that slot becomes a primary uplink port and the
corresponding backup port, 23R or 24R, automatically transitions to
redundant uplink status. Any settings for port mirroring remain intact
when the backup port makes the transition to a redundant uplink
state.
Examples
The following command enables mirroring and makes port 11 the
destination port:
set switch mirror=11
The following command disables port mirroring:
set switch mirror=0