Allied Telesis AT-S63 - Manual (Page 235)

AT-S63 Management Software Command Line Interface User’s Guide
235
SET DOS SYNFLOOD
Syntax
set dos synflood port= port state=enable|disable
Parameters
port Specifies the switch ports on which you want to enable
or disable this DoS defense. You can select more than
one port at a time.
state Specifies the state of the DoS defense. The options
are:
enable Activates the defense.
disable Deactivates the defense. This is the default.
Description
This command activates and deactivates the SYN ACK Flood DoS
defense.
In this type of attack, an attacker, seeking to overwhelm a victim with TCP
connection requests, sends a large number of TCP SYN packets with
bogus source addresses to the victim. The victim responds with SYN ACK
packets, but since the original source addresses are bogus, the victim
node does not receive any replies. If the attacker sends enough requests
in a short enough period, the victim may freeze operations once the
requests exceed the capacity of its connections queue.
To defend against this form of attack, a switch port monitors the number of
ingress TCP-SYN packets it receives. If a port receives more 60 TCP-SYN
packets per second, the following occurs.
ˆ The switch sends a trap to the management stations
ˆ The port discards all ingress TCP-SYN packets for a one minute
period.
This defense mechanism does not involve the switch’s CPU. You can
activate it on as many ports as you want without it impacting switch
performance.