Allied Telesis AT-S63 - Manual (Page 122)

Chapter 7: Port Parameter Commands
122
SHOW SWITCH PORT
Syntax
show switch port[= port ]
Parameter
port Specifies the port whose parameter settings you want
to view. You can specify more than one port at a time.
You can specify the ports individually (for example,
5,7,22), as a range (for example, 18-23), or both (for
example, 1,5,14-22). All ports are displayed if you
omit the port number.
Description
This command displays a port’s operating parameters, such as speed and
duplex mode. For details on port parameters, refer to Chapter 6, “Port
Parameters” in the AT-S63 Management Software Menus
Interface User’s Guide.
Examples
The following command displays the operating settings for all ports:
show switch port
The following command displays the operating settings for port 14:
show switch port=14