Restart reboot, Syntax, Parameters – Allied Telesis AT-S63 User Manual

Page 44: Description, Example

Text mode
Original mode

Chapter 3: Basic Switch Commands

RESTART REBOOT

Syntax

restart reboot

Parameters

None.

Description

This command resets the switch. The switch runs its internal diagnostics,
loads the AT-S63 management software, and configures its parameter
settings using the current boot configuration file. The reset takes
approximately 20 to 30 seconds to complete. The switch does not forward
traffic during the time required to run its internal diagnostics and initialize
its operating software. Some network traffic may be lost.

Note

Be sure to use the SAVE CONFIGURATION command to save your
changes before resetting the switch. Any unsaved changes are lost.

Example

The following resets the switch:

restart reboot