Allied Telesis AT-S63 - Manual (Page 114)

Chapter 7: Port Parameter Commands
114
Note
When a transceiver is inserted into an uplink slot and a link is
established on an AT-9424 switch, that slot becomes a primary
uplink port and the corresponding backup port, 23R or 24R,
automatically transitions to redundant uplink status. The speed and
duplex mode of the redundant port automatically transitions to
autonegotiate to match the speed of the primary uplink port and you
cannot configure the MDI/MDIX crossover parameter.
status Specifies the operating status of the port. The
options are:
enabled The port forwards Ethernet frames.
This is the default setting.
disabled The port does not forward frames.
unkmcastegressfiltering Controls the unknown multicast egress filter.
The options are:
yes, on, true, enabled The port forwards
unknown multicast
frames. These
options are
equivalent.
no, off, false, disabled The port discards all
unknown multicast
frames. These
options are
equivalent.
unkmcastfiltering Controls the unknown multicast filter. The
options are:
yes, on, true, enabled The port forwards
unknown multicast
frames. These options
are equivalent.
no, off, false, disabled The port discards all
unknown multicast
frames. These options
are equivalent.
unkucastegressfiltering Controls the unknown unicast egress filter. The
options are:
yes, on, true, enabled The port forwards
unknown multicast