Allied Telesis AT-S63 - Manual (Page 309)

AT-S63 Management Software Command Line Interface User’s Guide
309
CREATE SNMPV3 ACCESS
Syntax
create snmpv3 access= access [securitymodel=v1|v2c|v3]
[securitylevel=noauthentication|authentication|
privacy] readview=
readview writeview= writeview
notifyview= notifyview [storagetype=volatile|nonvolatile]
Parameters
access Specifies the name of the security group, up to 32
alphanumeric characters.
securitymodel Specifies the security model. The options are:
v1 Associates the Security Name, or User
Name, with the SNMPv1 protocol.
v2c Associates the Security Name, or User
Name, with the SNMPv2c protocol.
v3 Associates the Security Name, or User
Name, with the SNMPv3 protocol.
securitylevel Specifies the security level. The options are:
noauthentication This option provides no authentication protocol and
no privacy protocol.
authentication This option provides an authentication protocol, but
no privacy protocol.
privacy This option provides an authentication protocol and
the privacy protocol.
readview Specifies a Read View Name that allows the users
assigned to this Group Name to view the
information specified by the View Table entry. This
is an optional parameter. If you do not assign a
value to this parameter, then the readview
parameter defaults to none.
writeview Specifies a Write View Name that allows the users
assigned to this Security Group to write, or modify,
the information in the specified View Table. This is
an optional parameter. If you do not assign a value
to this parameter, then the writeview parameter
defaults to none.