Allied Telesis AT-S63 - Manual (Page 534)

Chapter 37: TACACS+ and RADIUS Commands
534
ADD RADIUSSERVER
Syntax
add radiusserver server|ipaddress= ipaddress order= value
[secret= string ] [port= value ] [accport= value ]
Parameters
server Specifies an IP address of a RADIUS server. The
parameters
ipaddress are equivalent.
order Specifies the order that the RADIUS servers are queried by
the switch. This value can be from 1 to 3. The servers are
queried starting with 1.
secret Specifies the encryption key used for this server.
port Specifies the UDP (User Datagram Protocol) port of the
RADIUS server. The default is port 1812.
accport Specifies the UDP port for RADIUS accounting. The default
is port 1813.
Description
This command specifies the IP addresses of RADIUS servers and the
order they are to be queried by the switch. There can be up to three
servers, but you must specify each one individually with this command.
You may specify an encryption key, a RADIUS UDP port, and a RADIUS
accounting UDP port.
Examples
The following command adds a RADIUS server with the 149.245.22.22 IP
address and specifies it as the first server in the list:
add radiusserver ipaddress=149.245.22.22 order=1
The following command adds the RADIUS server with the IP address
149.245.22.22. In addition, it specifies the server as the third RADIUS
server to be queried by the switch and has a UDP port of 3.
add radiusserver ipaddress=149.245.22.22 order=3 port=3
The following command adds a RADIUS server with an IP address of
149.245.22.22. In addition, it specifies the order is 2, the encryption key is
tiger74, and the UDP port is 1811.